VPI Aries 3

• The 1.75″-thick platter is comprised of non-resonant acrylic and incorporates an inverted bearing similar to that used in the HR-X. The bearing shaft is 60 Rockwell hardness, ground and polished, and the platter rotates on a Teflon/Delrin composit thrust plate for ultra low noise.

• The solid stainless steel motor assembly is almost 15 pounds and contains a smooth 300-RPM synchronous motor with Delrin motor pulley. This is a very low noise system with the fundamental resonance of the motor at 5 Hertz which is well below the frequency a cartridge can reproduce.

• The Aries 3 chassis is made from a sandwich of 2 layers of 5/8” polished black acrylic top and bottom with a 5/8” thick aluminum center section, exactly like the HR-X chassis design which provides stability and damping. This system creates an inert, quiet, and stable platform for the platter and tonearm to sit on. The plinth is supported by four aluminum cones, the bottoms of which are composed of hardened steel balls. The cone suspension when applied to the laminated HR-X type chassis provides outstanding rigidity and a wealth of information from the record grooves. They are adjustable for leveling.

• The Aries 3 circular armboard is a 4” Sdiameter, 1″ thick black acrylic that mates sonically with the HR-X style laminated chassis.

• The Aries 3 is available with or without a VPI tonearm.

• For best sound VPI recommends the Aries 3 with JMW-10.5i tonearm for a truly musical system.

• The Aries 3 can be taken to the next level by adding VPI’s Synchronous Drive System, periphery ring, new Mini TNT feet, and HR-X center weight at an additional cost.

Dimensions:

• 20 1/2″ x 15 1/2″ x 10″
• Footprint: 19 1/4″ x 14 1/4″
• Diameter of single foot: 2 1/4″ D
• Platter Height: 2″
• Platter Weight: 20 pounds
• Total Weight: 70 pounds